[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

5501 dmesg

Bon, personne n'a encore posté de dmesg à propos du nouveau Soekris
5501, voici chose faite, je l'ai reçu en fin de matinée et installé
aussitôt :) Vous noterez aussi la très sympathique ligne commençant
par glxsb0 :)

 5 Seconds to automatic boot.   Press Ctrl-P for entering Monitor.
Using drive 0, partition 3.
Loading...
probing: pc0 com0 com1 pci mem[639K 511M a20=on]
disk: hd0+
>> OpenBSD/i386 BOOT 2.13
-
com0: 19200 baud
switching console to com0
>> OpenBSD/i386 BOOT 2.13
boot>
booting hd0a:/bsd: 5566740+871228 [52+283664+263996]=0x6a9944
entry point at 0x200120û
[ using 548084 bytes of bsd ELF symbol table ]
Copyright (c) 1982, 1986, 1989, 1991, 1993
        The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-2007 OpenBSD. All rights reserved.
http://www.OpenBSD.org

OpenBSD 4.1-stable (GENERIC) #1: Fri Jun  1 10:33:40 CEST 2007

root AT compaq2 POINT intranet.dev1-0.org:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: Geode(TM) Integrated Processor by AMD PCS ("AuthenticAMD"
586-class) 500 MHz
cpu0: FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CFLUSH,MMX
real mem  = 536440832 (523868K)
avail mem = 481771520 (470480K)
using 4278 buffers containing 26947584 bytes (26316K) of memory
mainbus0 (root)
bios0 at mainbus0: AT/286+ BIOS, date 20/70/06, BIOS32 rev. 0 @0xfac40
pcibios0 at bios0: rev 2.0 @ 0xf0000/0x10000
pcibios0: pcibios_get_intr_routing - function not supported
pcibios0: PCI IRQ Routing information unavailable.
pcibios0: PCI bus #0 is the last bus
bios0: ROM list: 0xc8000/0xa800
cpu0 at mainbus0
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 1 function 0 "AMD Geode LX" rev 0x31
glxsb0 at pci0 dev 1 function 2 "AMD Geode LX Crypto" rev 0x00: RNG AES
vr0 at pci0 dev 6 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 11, address 00:00:24:c8:b3:38
ukphy0 at vr0 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034
vr1 at pci0 dev 7 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 5, address 00:00:24:c8:b3:39
ukphy1 at vr1 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034
vr2 at pci0 dev 8 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 9, address 00:00:24:c8:b3:3a
ukphy2 at vr2 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034
vr3 at pci0 dev 9 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 12, address 00:00:24:c8:b3:3b
ukphy3 at vr3 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034
pcib0 at pci0 dev 20 function 0 "AMD CS5536 ISA" rev 0x03 pciide0 at pci0 dev 20 function 2 "AMD CS5536 IDE" rev 0x01: DMA,
channel 0 wired to compatibility, channel 1 wired to compatibility wd0 at pciide0 channel 0 drive 1: <SILICONSYSTEMS INC 256MB>
wd0: 1-sector PIO, LBA, 248MB, 508928 sectors
wd0(pciide0:0:1): using PIO mode 4, DMA mode 2
pciide0: channel 1 ignored (disabled)
ohci0 at pci0 dev 20 function 4 "AMD CS5536 USB" rev 0x02: irq 15,
version 1.0, legacy support
usb0 at ohci0: USB revision 1.0
uhub0 at usb0
uhub0: AMD OHCI root hub, rev 1.00/1.00, addr 1
uhub0: 4 ports with 4 removable, self powered
ehci0 at pci0 dev 20 function 5 "AMD CS5536 USB" rev 0x02: irq 15
ehci0: pre-2.0 USB rev
isa0 at pcib0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
spkr0 at pcppi0
nsclpcsio0 at isa0 port 0x2e/2: NSC PC87366 rev 9: GPIO VLM TMS
gpio0 at nsclpcsio0: 29 pins
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pccom0: console
pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
biomask e5c5 netmask ffe5 ttymask ffe7
pctr: user-level cycle counter enabled
mtrr: K6-family MTRR support (2 registers)
dkcsum: wd0 matches BIOS drive 0x80
root on wd0a
rootdev=0x0 rrootdev=0x300 rawdev=0x302
Automatic boot in progress: starting file system checks.
/dev/rwd0a: file system is clean; not checking
setting tty flags
kbd: keyboard mapping set to fr
starting network
DHCPDISCOVER on vr0 to 255.255.255.255 port 67 interval 2
DHCPOFFER from 192.168.0.10
DHCPREQUEST on vr0 to 255.255.255.255 port 67
DHCPACK from 192.168.0.10
bound to 192.168.0.171 -- renewal in 43200 seconds.
starting system logger
starting initial daemons: ntpd.
savecore: no core dump
checking quotas: done.
building ps databases: kvm dev.
clearing /tmp
starting pre-securelevel daemons:.
setting kernel security level: kern.securelevel: 0 -> 1
creating runtime link editor directory cache.
preserving editor files
starting network daemons: sendmail inetd sshd.
starting local daemons:.
standard daemons: cron.
Mon Jun 25 19:10:15 CEST 2007

OpenBSD/i386 (5501-01.my.domain) (tty00)

login:

-- 
Serge