[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [obsdfr-misc] Soekris NET 4801 - Flashdist compilation error
bonjour.
cela donne quoi un petit "df -h" sur le systeme ?
On Sat, Oct 14, 2006 at 04:49:20PM +0200, lionel.deval wrote:
> Bonjour,
>
> En effet, mon erreur venait bien d'une incompatibilité, je viens de
> mettre la main sur une 3.9 et la compilation à réussi.
> Cependant, me voilà confronté à un nouveau problème lors du lancement
> du script flashdist.sh.
>
> La compact Flash (kingstom 512Mo) sur lequel j'effectue mon
> installation est vierge de tout système et mon lecteur CF reconnu par
> OpenBSD.
> Le script est censé faire une raz totale des partitions et des
> données présente sur la CF mais pourtant l'installation plante à
> cause d'un manque de place.
> Flashdist rentre normalement sur une carte inférieure à 512Mo alors
> pourquoi refuse t-elle de s'installer ?
>
> # ./flashdist.sh sd0 flashsmall.txt /usr/src/sys/arch/i386/compile/
> NET4801/bsd /tmp/openbsd/
> flashdist.sh 20060413 chris AT nmedia POINT net
> Using disk device: sd0
> Using distfile: flashsmall.txt
> Copying kernel from: /usr/src/sys/arch/i386/compile/NET4801/bsd
>
> You did not specify -d and you did not specify a manual geometry.
> Please enter Cylinders/Heads/SectorsPerTrack.
>
> Cylinders: 993
> Tracks Per Cylinder(Heads): 16
> Sectors Per Track: 63
>
> Please pay attention to any error messages that you may
> receive from the commands this script is using. If you
> end up having problems, they could explain why.
>
> WARNING: This will erase ALL DATA on the sd0 disk device!
> Press enter key to continue or Control-C to abort...
>
> Updating MBR and partition table...
> fdisk: sysctl(machdep.bios.diskinfo): Device not configured
> Note, you may ignore "sysctl(machdep.bios.diskinfo)" errors if present.
>
> Setting up disklabel...
> # Inside MBR partition 3: type A6 start 63 size 1000881
>
> The install script is using the following parameters:
> Total size of media: 1000944 sectors (512483328 bytes)
> Bytes/Sector: 512
> Sectors/Track: 63
> Sectors/Cylinder: 1008
> Tracks/Cylinder (heads): 16
> Cylinders: 993
>
> Press enter key to continue or Control-C to abort...
>
> Checking distribution list...
>
> /tmp: write failed, file system is full
> tar: Failed write to file ./usr/lib/libasn1.so.15.0: No space left on
> device
>
> /tmp: write failed, file system is full
> tar: Failed write to file ./usr/lib/libc.so.39.0: No space left on
> device
>
> /tmp: write failed, file system is full
> tar: Failed write to file ./usr/lib/libcrypto.so.12.0: No space left
> on device
>
> /tmp: write failed, file system is full
> tar: Failed write to file ./usr/lib/libcurses.so.10.0: No space left
> on device
>
> /tmp: write failed, file system is full
> tar: Failed write to file ./usr/lib/libdes.so.9.0: No space left on
> device
>
> /tmp: write failed, file system is full
> tar: Failed write to file ./usr/lib/libedit.so.3.0: No space left on
> device
>
> /tmp: write failed, file system is full
> tar: Failed write to file ./usr/lib/libevent.so.1.1: No space left on
> device
>
> /tmp: write failed, file system is full
> tar: Failed write to file ./usr/lib/libgssapi.so.4.0: No space left
> on device
>
> /tmp: write failed, file system is full
> tar: Failed write to file ./usr/lib/libkvm.so.8.0: No space left on
> device
>
> /tmp: write failed, file system is full
> tar: Failed write to file ./usr/lib/libm.so.2.1: No space left on device
>
> /tmp: write failed, file system is full
> tar: Failed write to file ./usr/lib/libpcap.so.4.0: No space left on
> device
>
> /tmp: write failed, file system is full
> tar: Failed write to file ./usr/lib/librpcsvc.so.1.0: No space left
> on device
>
> /tmp: write failed, file system is full
> tar: Failed write to file ./usr/lib/libskey.so.5.1: No space left on
> device
>
> /tmp: write failed, file system is full
> tar: Failed write to file ./usr/lib/libutil.so.11.0: No space left on
> device
>
> /tmp: write failed, file system is full
> tar: Failed write to file ./usr/lib/libwrap.so.4.0: No space left on
> device
>
> /tmp: write failed, file system is full
> tar: Failed write to file ./usr/lib/libz.so.4.1: No space left on device
> strip: /tmp/flashdist.mFl16059/./usr/lib/libasn1.so.15.0: File truncated
>
> /tmp: write failed, file system is full
> strip: /tmp/flashdist.mFl16059/./usr/lib/libc.so.39.0: File truncated
>
> /tmp: write failed, file system is full
> strip: /tmp/flashdist.mFl16059/./usr/lib/libcrypto.so.12.0: File
> truncated
>
> /tmp: write failed, file system is full
> strip: /tmp/flashdist.mFl16059/./usr/lib/libcurses.so.10.0: File
> truncated
>
> /tmp: write failed, file system is full
> strip: /tmp/flashdist.mFl16059/./usr/lib/libdes.so.9.0: File truncated
>
> /tmp: write failed, file system is full
>
> /tmp: write failed, file system is full
> strip: /tmp/flashdist.mFl16059/./usr/lib/libevent.so.1.1: File truncated
>
> /tmp: write failed, file system is full
> strip: /tmp/flashdist.mFl16059/./usr/lib/libgssapi.so.4.0: File
> truncated
>
> /tmp: write failed, file system is full
> strip: /tmp/flashdist.mFl16059/./usr/lib/libkafs.so.15.0: File truncated
>
> /tmp: write failed, file system is full
> strip: /tmp/flashdist.mFl16059/./usr/lib/libkrb5.so.15.0: File truncated
>
> /tmp: write failed, file system is full
>
> /tmp: write failed, file system is full
>
> /tmp: write failed, file system is full
>
> /tmp: write failed, file system is full
>
> /tmp: write failed, file system is full
>
> /tmp: write failed, file system is full
> strip: /tmp/flashdist.mFl16059/./usr/lib/libtermcap.so.10.0: File
> truncated
>
> /tmp: write failed, file system is full
>
> /tmp: write failed, file system is full
>
> /tmp: write failed, file system is full
>
> /tmp: write failed, file system is full
>
> Installing disklabel...
> # Inside MBR partition 3: type A6 start 63 size 1000881
>
> Creating new filesystem...
> /dev/rsd0a: 999872 sectors in 992 cylinders of 16 tracks, 63 sectors
> 488.2MB in 12 cyl groups (86 c/g, 42.33MB/g, 10752 i/g)
>
>
> Mounting destination to /tmp/flashdist.VyoF24842...
> Checking free space on sd0...
>
> /tmp: write failed, file system is full
>
> /tmp: write failed, file system is full
> gzip: /usr/src/sys/arch/i386/compile/NET4801/bsd: No space left on
> device
> Copying OpenBSD distribution to media...
> /tmp: write failed, file system is full
> tar: End of archive volume 1 reached
> tar: Sorry, unable to determine archive format.
> Segmentation fault
> done
> Copying bsd kernel, boot blocks, /etc/resolv.conf...
> Installing boot blocks...
> using MBR partition 3: type 166 (0xa6) offset 63 (0x3f)
> Running MAKEDEV...done
> Setting up directories and links...
> Changing any instance of /bin/csh in /tmp/flashdist.VyoF24842/etc/
> master.passwd to /bin/ksh
> Generating new RSA host key... done
> Generating new RSA1 host key... done
> Generating new DSA host key... done
>
> Please assign a root password...
> Password:
> Verify:
>
> Copying configuration files to /etc... ttys fstab rc syslog.conf
> boot.conf nshrc
>
> Please enter the hostname or IP address of the central log host which
> will
> receive udp syslog packets from this installation. (Press enter for
> none,
> and syslog will log to ramdisk)
>
> Loghost: soekris
>
> Installation finished.
> Unmounting filesystem...done!
>
> ma CF :
>
> # disklabel -pm sd0
> # Inside MBR partition 3: type A6 start 63 size 1000881
> # /dev/rsd0c:
> type: SCSI
> disk: SCSI disk
> label: STORAGE DEVICE
> flags:
> bytes/sector: 512
> sectors/track: 63
> tracks/cylinder: 16
> sectors/cylinder: 1008
> cylinders: 993
> total bytes: 488.7M
> rpm: 3600
> interleave: 1
> trackskew: 0
> cylinderskew: 0
> headswitch: 0 # microseconds
> track-to-track seek: 0 # microseconds
> drivedata: 0
>
> 16 partitions:
> # size offset fstype [fsize bsize cpg]
> a: 488.2M 0.0M 4.2BSD 1024 8192 86 # Cyl
> 0*- 991
> b: 0.0M 488.2M swap # Cyl
> 992 - 992*
> c: 488.7M 0.0M unused 0 0 # Cyl
> 0 - 992
>
>
>
> Pouvez-vous m'aider , je bloque complètement :-/
> Merci d'avance
>
> Lionel
>
> Le 9 oct. 06 à 16:31, Miod Vallat a écrit :
>
> >>J'aimerai installer flashdist sur mon soekris 4801 malheureusement
> >>lors de la compilation de mon noyau, j'ai une erreur code 1.
> >[...]
> >>/usr/src/sys/sys/systm.h:163: warning: conflicting types for built-in
> >> function `vsnprintf'
> >>/usr/src/sys/sys/systm.h:165: warning: conflicting types for built-in
> >> function `snprintf'
> >(etc)
> >
> >>Je ne comprend pas la source de cette erreur, quelqu'un a t-il déjà
> >>rencontré ce type de problème ou connais la solution pour que ma
> >>compilation se termine sans accros ?
> >
> >Tu es en train de compiler des sources OpenBSD 3.9 ou plus récentes
> >avec
> >un compilateur OpenBSD 3.8 ou plus ancien (pour être plus précis,
> >les sources
> >sont postérieurs au 13 janvier 2006, et le compilateur est antérieur à
> >cette date).
> >
> >Ce n'est pas supporté. Il faut utiliser le compilateur de la
> >version que
> >l'on souhaite compiler.
> >
> >Miod
> >
> >---------------------------------------------------------------------
> >To unsubscribe, e-mail: openbsd-france-misc-unsubscribe AT openbsd-
> >france.org
> >For additional commands, e-mail: openbsd-france-misc-help AT openbsd-
> >france.org
> >
> >
>
--
Nanard !!! nanard AT free POINT fr
Tchenbe red pa moli, se moli a ki red !